BLODGETT
www.blodgett.com
44 Lakeside Avenue, Burlington, VT 05401 Toll Free: (800) 331-5842 • Phone: (802) 860-3700 • Fax: (802) 864-0183
SC-E CONVECTION STEAMER
SHORT FORM SPECIFICATIONS
Provide Blodgett model SC-7E (7 pan), SC-10E (10 pan) convection steamer with electric steam generator mounted on a 24” wide cabinet base. The SC-7E is comprised of one 3 pan
compartment on top of one 4 pan compartment. The SC-10E is comprised of two 5 pan compartments. Each compartment shall have it’s own steam generator. Unit shall be constructed
of satin finish 304 stainless steel with a one piece 316 welded stainless steel cooking chamber with coved corners. The door shall have a removable inner liner of stainless steel with full
perimeter gasket seal, an outer liner of one-piece all welded stainless steel, and a positive lock and seal mechanism with spring release. Each compartment shall have removable stain-
less steel pan supports and a stainless steel drip trough integrally connected to collect and drain condensate with the doors are open. The control housing shall be constructed of stain-
less steel with a full access removable panel. The controls shall include an illuminated on/off/delime power switch, a ready indicator light, cooking indicator light, 60 minute electric timer
with audible alarm that signals the end of the cook cycle, solid state generator controls and delime mode power setting. Steam flow to the compartment shall be cut off when the door is
opened during the cook cycle and shall be reactivated when the door is closed. Unit shall have a deliming port located in the rear. The unit shall have an automatic generator blow down
and split water connections. Provide options and accessories as indicated.
WATER SUPPLY:
Water quality is a major factor affecting the performance of your steamer. If you are unsure
of water quality, consult a local water treatment specialist and have the water analyzed.
Your water supply must be within these general guidelines:
Total dissolved solids: Less than 60 PPM
Total alkalinity: Less than 20 PPM
Silica:
Less than 13 PPM
Chlorine:
Less than 1.5 PPM
pH Factor:
7.0 - 8.5
Water which fails to meet these standards should be treated by installation of a water
conditioner. Failure or malfunction of this steamer due to poor water quality is not covered
under warranty.
WATER & DRAIN CONNECTIONS:
Drain
1” (25mm) IPS piped to open floor drain. No solid connection.
24” length before open air gap opening (no bends or elbows)
Cold Water
3/8” (10mm) tubing at 25-50 PSI (170-345 kPa)
MAXIMUM INPUT:
SC-7E
17.5 kW
SC-10E 30 kW
POWER CONNECTION:
1-1/8” (29mm) hole for electrical connection
SHIPPING INFORMATION:
Approx. Weight:
SC-7E
400 lbs. (181 kg)
SC-10E 450 lbs. (204 kg)
Printed in U.S.A.
NOTE:
FOR COMMERCIAL USE ONLY
NOTE:
The company reserves the right to make substitutions of components without prior notice.
APPROVAL/STAMP
P/N S00010 Rev F (3/08)
AMPS PER LINE
kW Phase 208V
220V
240V
380V
480V
17.5
3
49
63
57.8
36.5
28.9
30
3
99.9
94.5
86.6
54.7
43.3