7
Installation
oven assembly
4” (10cM) LeG attachMent
1. Lay the oven on its side.
2. Screw one leg into each of the corner nuts.
figure 5
casteR instaLLation
NOTE: Casters are not supplied for the 4” (10cm) legs,
5-3/4” (15cm) or 7” (18cm) stands.
NOTE: Install the locking casters on the front of the
oven. Install the non-locking casters on the back
of the oven.
1. Insert the caster into the leg. Secure the caster to the
leg by tightening the locknut.
oven LeveLinG
After assembly, the oven should be leveled and moved
to the operating location.
1. The oven can be leveled by adjusting the feet or cast-
ers located on the bottom of each leg.
aDjUstMents associateD With initiaL instaL-
Lation
Each oven, and its component parts, have been thor-
oughly tested and inspected prior to shipment. However,
it is often necessary to further test or adjust the oven as
part of a normal and proper installation. These adjust-
ments are the responsibility of the installer, or dealer.
Since these adjustments are not considered defects in
material or workmanship, they are not covered by the
Original Equipment Warranty. They include, but are not
limited to:
• calibration of the thermostat
• adjustment of the doors
• leveling
• tightening of fasteners.
No installation should be considered complete without
proper inspection, and if necessary, adjustment by quali-
fied installation or service personnel.