BB 10000-D - Front panel
The BB 10000-D front panel contains the following components:
BB 10000-D - Front Panel
1.
:
Power LED
If the LED is lit, it demonstrates that the system is on. If the LED is off, it indicates that the system is offline;
2.
:
HDD LED
Demonstrates data access activities flashing the LED; Otherwise, the LED remains off;
3. LCD System Panel:
LCD graphical module with 4 buttons, displayed system information, are respectively:
:
DataSpace Determines the amount of disk space;
:
Load Average Average values of processes waiting execution;
:
Uptime Determines how long the appliance is active;
:
RAM Free Determines how much free RAM the appliance has.
4. Console Port:
Using a suitable console cable, it’s possible to connect to a terminal for diagnostic or configuration purposes. Parameters to configure the terminal: 115200
baud, 8 bits of data, no parity, 1st bit and no flow control, for more information, check the
chapter;
5.
2.0 Port:
USB
Allow you to connect to any USB device, for example, a flash drive;
6.
:
Reset Button
Allow the system to be reset without disconnecting the power cable, use a narrow object to push the button;
7.
:
Gigabit LAN Port
Eth0 is the main interface, it is a dynamic WAN interface, used for internet access and device provisioning, for more information see the chapter on Zero
Touch Provisioning in the GSM manual.
Eth1 is the management interface with the standard IP for configuring your appliance, for more information on these procedures, consult the appropriate
manual at the Blockbit Resource Center.
Right LED: If the LED is orange, it indicates that the connection speed is 100Mbps, if the LED is green, indicates that the connection speed is of
1000 Mbps;
Left LED: If the LED is lit, it indicates that the port is active. If it flashes, indicate that there is traffic. If the LED is off, the port is also off.
Using an RJ-45 cable, it’s possible to connect this appliance to a computer, a hub, a switch or any other equipment capable of making an Ethernet
connection. In addition, 1 pair (LAN2-LAN2) can be configured to do a
