24
25
Remote control (optional)
1.
Standby button: to turn On/OFF the SB-50 MKII
2.
Increases the volume.
3.
Play/pause button: for media such as USB, Blue-
tooth and Spotify.
4.
Reward button: plays a previous track on media
such as USB, Bluetooth, and Spotify.
5.
Forward button: plays a next track on media such as
USB, Bluetooth, and Spotify.
6.
TReduces the volume.
7.
Channel button (behind material): controls the
operating mode of the SB-50 MKII. Available are: left
channel, right channel and single stereo system.
Observe the Status display of the red and green LED.
8.
Mute button: turns the sound off, but the track
continues.
9.
AUX | BT button: switches the SB-50 MKII to playback
of the „Bluetooth“ source.
10.
Internet radio button: switches the SB-50 MKII to
playback of the „Internet radio“ source.
11.
Spotify button: switches the SB-50 MKII to play of
the „Spotify“ source.
12.
DAB | FM button: press once switches the SB-50
MKII to play of the „DAB + radio“ source, press again
to switch the SB-50 MKII to play of the „FM radio“
source.
L/R
AUX/BT
i-RADIO
SPOTIFY
DAB/FM
+
-
x
1
3
4
7
9
11
2
5
6
8
10
12
Structure of the SB-50 MKII
1.
Unpack all components and decide whether you want to install the SB-50 MKII normally or to mount it on a
wall.
2.
Installation without wall mounting
Loosen the crews on both sides of the SB-50 MKII using an Allen key (hex key). Then, remove the wall
holder from the unit and place it back into the packaging material. Close the holes on the sides with the
provided rubber stoppers. According to the installation (side or upright), you can attach additional self-
adhesive rubber feet. Your SB-50 MKII is now ready for installation without wall mounting.
3.
Wall mounting
Loosen the crews on both sides of the SB-50 MKII using an Allen key (hex key). Then remove the wall
holder from the unit and install it on the desired place on your wall. The wall holder can be installed
directly in a corner of your room. Follow step 4 (connecting) of the set-up instructions and then plug the
loudspeaker onto the wall bracket. Mount the two lateral screws with an Allen key size 4.
4.
Connecting
Connect the cable of the enclosed power transformer to the SB-50 MKII. Plug the power transformer into
an electrical outlet.
Operating the SB-50 MKII
1.
After switching on, the SB-50 MKII should be on the setup mode (blue LED flashes). Should this not be the
case or if you want to carry out a new configuration, press the standby button on the front panel until the
unit returns to the factory default settings and wait until the blue LED on the front panel starts flashing.
2.
Configuration Install the free app „UNDOK ™“ on your Smartphone or tablet. This is available in the
respective stores for iOS and android.
3.
Open the Wi-Fi settings on your Smartphone or tablet and connect it to the SB-50 MKII (not with your
home WLAN)
4.
Follow the enclosed instructions for the „UNDOK ™“ app.
