Page 9
Tournado™ WiMAX 7 Manual Rev. A
Copyright 2018 Blizzard Lighting, LLC
Fixture Linking (Master/Slave Mode)
1. Connect the (male) 3-pin connector side of the DMX cable
to the output (female) 3-pin connector of the first fixture.
2. Connect the end of the cable coming from the first fixture
which will have a (female) 3-pin connector to the input
connector of the next fixture consisting of a (male) 3-pin
connector. Then, proceed to connect from the output as stated
above to the input of the following fixture and so on.
A quick note:
Often, the setup for Master-Slave and Standalone operation requires
that the first fixture in the chain be initialized for this purpose via either settings
in the control panel or DIP-switches. Secondarily, the fixtures that follow may also
require a slave setting.
Check the “
Operating
Adjustments
” section in
this manual for complete
instructions for this type of
setup and configuration.
Mounting & Rigging
This fixture may be mounted
in any SAFE position
provided there is enough
room for ventilation.
It is important never to
obstruct the fan or vents
pathway. Mount the fixture
using a suitable “C” or “O”
type clamp. The clamp
should be rated to hold at least 10x the fixture’s weight to ensure structural stability.
Do not mount to surfaces with unknown strength, and ensure properly “rated”
rigging is used when mounting fixtures overhead.
Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After
finding the desired position, retighten both knobs.
• When selecting installation location, take into consideration lamp replacement
access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the fixture will be exposed to rain, high humidity,
extreme temperature changes or restricted ventilation.
