16
Power Hitch™ Instruction
Power Hitch
™
Instruction
Prior to operating your Power Plow snowplow review the Mounting &
Dismounting Instructions label at the driver’s side rear of the moldboard.
MOUNTING & DISMOUNTING
INSTRUCTIONS
Power Hitch Raises & Lowers
Behind Undercarriage Push Beam
MOUNTING
1.
Position vehicle close to the plow and align mounting points on the undercarriage and
A-frame. Verify that the plow kickstand is in the lowered position. Turn vehicle ignition off.
2.
Turn power supply switch on the main plow control unit in the vehicle to the “OFF” position.
3.
Remove protective weather caps and make electrical connection at the plow and vehicle.
4. Turn the vehicle ignition, and the power supply switch on the control unit, to the “ON”
position. Pull the A-frame latch lock pin outward and verify that the A-frame latch lowers
over the draw pin.
5.
Activate the Power Hitch on the A-frame by pushing and holding the “CONNECT/
DISCONNECT” switch (on the pump cover housing) upward.
CAUTION: Keep
fingers away from plow and truck mounting points. Power Hitch will
automatically pull the plow into the receiving points on the truck
when activated.
Insert both hitch pins through the positively aligned holes
on the plow and undercarriage and secure each with a hair pin cotter.
6. With the plow securely mounted, slightly lower the Power Hitch to relieve
tension on the A-frame latch, pull the latch lock pin and raise the A-frame
latch until it locks into position. Raise the Power Hitch and verify that the
draw latch is fully engaged behind the push beam on the vehicle. Rotate
the kickstand counterclockwise until it locks into place. The plow is now
properly mounted and ready to operate.
DISMOUNTING
1.
Lower the plow on a flat, level surface to dismount. Turn vehicle ignition off.
2.
Pull the kickstand lock pin outward and rotate the kickstand clockwise. Release the pin
to lock kickstand in place. Remove both hitch pins from the A-frame and undercarriage.
3.
Turn the vehicle ignition and the power supply switch on the control unit to the “ON”
position. Activate the Power Hitch by pushing and holding the “CONNECT/DISCONNECT”
switch downward.
CAUTION: Keep fingers away from plow and truck mounting points.
Verify that the draw latch is fully disengaged from behind the push beam on the vehicle.
4.
Turn power supply switch on the main plow control unit in the vehicle to the “OFF” position.
5.
Disconnect electrical cords at the plow and vehicle. Replace protective weather caps.
Adjustable
Kickstand
Draw
Latch
KEEP FINGER
S
AW
AY
!
BLZ 1023
A-Frame Latch
Lock Pin
Plug To Vehicle
Wire Harness
CONNECT /
DISCONNECT
Toggle Switch
A-Frame Latch
Rotates Clockwise
And Hooks Onto
Draw Pin
Draw
Pin
A-Frame
Latch
Lock Pin
A-Frame
Latch
TM
Should the Mounting & Dismounting Instructions
label or any of the labels that came with your
snowplow become hard to read or wear off, contact
your local authorized Blizzard dealer for
replacements.
Summary of Contents for Power Plow 8611
Page 19: ...Notes 17 Notes...
