CLEANING
1.
UNPLUG your chiller and remove any stock to a suitable back-up chiller.
2.
Wash the inner compartment with warm water and neutral detergent. DO NOT allow the
control panel, cables or plug to get wet.
NEVER use corrosive detergents, wire brushes, or abrasive scourers to clean your chiller.
NEVER use metal or sharp implements to remove debris.
3.
Dry all surface thoroughly.
4.
To ensure trouble-free operation the condenser should be cleaned every three months
where appropriate using a vacuum hose. The condenser is located behind lower grill at the
rear of the cabinet. In exceptionally dusty locations the condenser should be cleaned more
often.
5.
Use mild soapy water to clean the gasket and seals.
REPLACING LAMPS
1 Unplug the power plug.
2.
Remove the screws on both end of the light cover, take down the lamp cover, pull out
the wires, then take away the lamp.
3.
Install the new lamp, connect the wires, place the lamp cover and fasten it.
4.
Caution: If the lamp is damaged, it must be replaced by the manufacturer
，
its service
agent or similarly qualified persons in order to avoid hazard.
Pentland Wholesale Ltd, Blizzard House, Unit17 Walker Industrial Estate, Walker
Road, Blackburn, Lancashire, BB1 2QE.
Tel: 01254 614444,
www.pentlandwholesale.co.uk
5
DISPOSAL OF PACKAGING
Do not allow children to play the packaging, and destroy plastic bags safely.
The cardboard may be broken or cut into smaller pieces and given to a waste paper disposal
service. The wrapping foil is made of polyethylene. The polyethylene pads and stuffing
contain no fluorochloric hydrocarbons.
All these valuable materials may be taken to a waste collecting depot and used again after
adequate recycling. Consult your local authority for the name and address of the waste paper
disposal services nearest to you.
IMPORTANT SAFETY INSTRUCTIONS
Before switching on your chiller for the first time, read the information in this user manual
carefully. The manual contains important observations relating to the assembly, operation
and maintenance of the appliance.
Please keep this booklet in a safe place for future reference. If you ever sell your chiller, hand
this user manual to the new owner.
The manufacture does not accept responsibility for any damages that may arise due to non-
observation of these instructions. The user is liable for any material damage or bodily injury
(product liability) cause by using the refrigerator carelessly or failing to follow instructions.
2