Blizzard Lighting Redstone 240Z Wash, Manual

Page: 12 / 20

Page 12
Redstone™ 240Z Wash Manual - Rev. A (c) 2019 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
1.) Navigate the menu until you reach DMX , and press <ENTER> .
2.) Highlight DMX Address , and press <ENTER> .
3.) Use the <UP/DOWN> buttons to select a channel from 001-512 .
4.) Press the <ENTER> button to confirm.
Select the DMX Channel Mode:
1.) Navigate the menu until you reach DMX , and press <ENTER> .
2.) Highlight DMX Channel Mode , and press <ENTER> .
3.) Use the <UP/DOWN> buttons to select 21, 18, or 28-channel mode.
4.) Press the <ENTER> button to confirm.
Signal Selection:
1.) Navigate the menu until you reach DMX , and press <ENTER> .
2.) Highlight Connect to , and press <ENTER> .
3.) Use the <UP/DOWN> buttons to highlight either XLR Priority , Wireless Priority ,
XLR Only , Wireless Only , or ArtNet Only , and press <ENTER>.
Auto & Sound Active Modes
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Auto Mode:
1.) Navigate the menu until you reach SHOW , and press <ENTER> .
2.) Use the <UP/DOWN> buttons to highlight any available Auto mode.
3.) Press the <ENTER> button to confirm your selection.
4.) Ensure that DMX > Loss of DMX is set to M/S Mode .
Sound Active Mode:
1.) Navigate the menu until you reach SHOW , and press <ENTER> .
2.) Use the <UP/DOWN> buttons to highlight Sound Active .
3.) Press <ENTER> , highlight ON , then press the <ENTER> button to confirm.
4.) For mic sensitivity, highlight Mic Sensitivity , and press <ENTER> .
5.) Adjust the mic sensitivity from 0-100 , and press <ENTER> .
Setup Options
The setup menu contains a variety of user configurable fixture settings.
Pan/Tilt Inverse:
1.) Navigate the menu until you reach SET , and press <ENTER> .
2.) Now highlight Pan Inverse or Tilt Inverse , and press <ENTER> .
3.) To activate, use the <UP/DOWN> buttons to highlight Yes, and press <ENTER>.
PT Feedback: (pan/tilt autocorrect position)
1.) Navigate the menu until you reach SET , and press <ENTER> .
2.) Then navigate to P/T Feedback and press <ENTER>.
3.) Use the <UP/DOWN> buttons to highlight No or Yes, and press <ENTER>.
White Balance:
1.) Navigate the menu until you reach SET , and press <ENTER> .
2.) Then navigate to White Balance and press <ENTER>.
3.) From here, you can adjust the individual R/G/B levels from 000-255.