Page 13
N-Trance™ User Manual - Rev. A
(c) 2018 Blizzard Lighting, LLC
Display Reverse:
1.) Navigate the main menu to reach
Settings
, and then press the
<ENTER>
button.
2.) Highlight
Display Rev
. and then press
<ENTER>.
3.) Choose from
ON
(inverted 180°) or
OFF
, and press
<ENTER>
to confirm.
Display OFF/OFF:
1.) Navigate the main menu to
Settings
, and then press
<ENTER>.
2.) Highlight
Display
and then press
<ENTER>.
3.) Choose from
Hold
(continuous), or
OFF
(after 1 minute of inactivity). Press
<ENTER>
to confirm.
DMX Fail Settings:
1.) Navigate the main menu to
Settings
, and then press
<ENTER>.
2.) Highlight
DMX Fail
and then press
<ENTER>.
3.) Choose either
Hold
(holds last received signal), or
Blackout.
Press
<ENTER>
to confirm.
Dimming Mode Settings:
Use any 1 of 4 dimming curve settings for smoother (and slower) dimming capabilities.
DMX%
DMX%
DMX%
DMX%
Output
Output
Output
Output
(Linear)
(Exp)
(Log)
(S Curve)
Linear Curve
Exponential
Logarithmic
S-Curve
1.) Navigate the main menu until you reach Settings, press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to highlight
Dimmer Curve
, and press
<ENTER>
.
3.) Now you can use the
<UP/DOWN>
buttons to highlight
Linear, Exp
(exponential),
Log
(logarithmic), or
S Curve
. Press the
<ENTER>
button to confirm your selection.
Dimmer Response:
1.) Navigate the main menu until you reach
Settings,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to highlight
Dimmer Response,
and press
<ENTER>
.
3.) Now use the
<UP/DOWN>
buttons to highlight
LED
which the dimming responds abruptly to DMX
changes, or
Halogen
which is similar to that of a halogen lamp, with more gentle changes in brightness.
4.) Press
<ENTER>
to confirm your selection.
Pan/Tilt Reverse:
1.) Navigate the main menu until you reach
Settings,
press
<ENTER>
.
2.) Use the
<UP/DOWN>
buttons to highlight
Pan Rev
or
Tilt Rev,
and press
<ENTER>
.
3.) Now use the
<UP/DOWN>
buttons to highlight
OFF
or
ON
, and press
<ENTER>
to confirm.
Pan Angle:
1.) Navigate the main menu until you reach
Settings,
press
<ENTER>
. Then use the
<UP/DOWN>
buttons to highlight
Pan Angle > 540
or
630
degrees
,
and press
<ENTER>
to confirm.
Calibrate:
1.) For fine calibration adjustments, navigate the main menu until you reach
Settings,
then press
<ENTER>
. Now use the
<UP/DOWN>
buttons to highlight
Calibrate
then
<ENTER>,
and choose an
effect to adjust anywhere ranging from 0-255. When finished press
<ENTER>
to confirm.
Factory Reset:
1.) Navigate the main menu until you reach
Settings,
press
<ENTER>
. Then use the
<UP/DOWN>
buttons to highlight
Factory Reset > YES or NO
(to cancel)
,
and press
<ENTER>
.
