Assembly and Operating Manual
10
Fig. 32
and
33
-
Checking Ailerons and Elevators
- Check that the control surfaces respond to the appropriate
movements of the transmitter joysticks. If not, swap over the
servo lead at the receiver.
- Check the neutral position of the control surfaces; you may
need to screw the clevises in or out to correct any discrepancy.
- Stand behind the model.
- Check the direction of rotation of the servos:
- Move the aileron stick to the right (a), and the right aileron (a)
must rise up, the left aileron (b) fall down.
- Pull the elevator stick back towards you (c), and the
trailing edge of both elevators should rise (c).
- If either function works in the wrong way, correct it using your
transmitter’s servo reverse switch for that channel.
Fig. 34
-
Checking the power system
- Hold the model securely.
- Remove any loose objects such as cloths, tools, etc. from the
area in front of the model, as they could easily be sucked into
the ducted fan.
- Open the throttle (stick forward): the motor should now run and
you should feel a strong air flow rushing out from the tail end of
the model.
- Move the throttle stick back to the “OFF” position.
- Disconnect the battery from the electronic speed controller and
then switch the transmitter off.
