Blitz BZE5P, User Manual

Page: 9 / 12

7
S y s t e m w i r i n g
Head unit (Stereo, DVD Player, Tape Deck, etc.)
Parametric Equalizer
REAR CHANNEL
Power Amplifier
FRONT CHANNEL
Power Amplifier
to Remote On
(Orange)
to +12v Battery
(Red)
Left and Right
Line Inputs
Rear Panel
Left and Right
Line Outputs
from Head Unit
REAR CHANNEL
Speakers
FRONT CHANNEL
Speakers
Fuse: 1A
SUB CHANNEL
Speakers
SUB CHANNEL
Power Amplifier
front rear
Volume
Fader Mid
– + – +
Low
– +
Sub
– +
– +
Freq.
Subwoofer
0 +10dB 40 400
Gain
Aux
Def
– +
High
to Ground (Black)
– +
– +
– +
– +
– +
– +
Connect 12V DC from a constant battery source to a +12V slip-on spade terminal and install
a one (1) amp fuse in line.
Connect the signal processor’s GROUND to a good chassis ground, near where the unit is
mounted, or to the case of the head unit.
Connect the signal processor’s REMOTE TURN-ON lead to the remote turn-on lead out of
the head unit, and install a 1/2 amp fuse in line. (A relay should be used if turning on more
than one component, such as EQ’s, crossovers or amplifiers.)
Connect stereo RCA cables from the head’s left and right front outputs to the left and right
inputs of the signal processor.
Connect stereo RCA cables from the left and right outputs, (and low, mid and high outputs
if applicable), of the signal processor to the left and right inputs of your amplifier(s) or
additional signal processor(s).
Turn the unit on, and adjust the input gain on the signal processor to match the output of
the head unit (1/2, or at center position, is about 1 V). Be careful not to overdrive the input
of your amplifier(s) or signal processor(s). Use clip detectors to adjust output.
Adjust each of the crossover or equalizer controls to achieve the desired sound characteristics.