BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
26
Issue 01 D1
4.
Using the DC connector on the end of the PSU DC power cable, connect the -48 Vdc power supply
cable to the X-1200 module DC power port. Provide a small loop in the DC power cable at the
bottom of the X-1200 to allow for movement.
Figure 18 Power Connection via the PSU
5.
With cable ties, use the dedicated cable tie slots on the side of the PSU mounting bracket to neatly
collect and contain (dress) the cables from the PSU. If needed, see section 6.11, “Cable
Management” for more information.
Figure 19 Module with PSU Installed.
6.6
Installing the Module onto a Mounting Bracket
Prerequisites:
Attached elevation and azimuth brackets on back of HM or RBM
Mounted pole/wall mounting bracket
Required parts and tools:
Pole/wall mount bracket locknut hardware from X-1200 Module Installation Kit (See Figure 20,
“Pole/Wall Mount Bracket Locknut Hardware”)
Socket wrench with 3/8 in. driver head, with long and short ½ in. and 7/16 in. sockets
Torque wrench, 3/8 in. head with range for 4-60Nm or 3-45lbf-ft
Figure 20 Pole/Wall Mount Bracket Locknut Hardware
DC Power Port
PSU DC Power Connector
On PSU, Dedicated Cable
Tie-down Management
Slots (x4)
Locknut
Washer
