BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
21
Issue 01 D1
To attach the elevation bracket onto the HM or RBM, refer to Figure 11, “Attaching Elevation Bracket to
Back of Module” and follow these steps:
1.
Place the elevation bracket on the back of the unit, in the top center position, with the orientation
cut-out (triangle) pointing up. Align the four bolt holes so that they are centered with the holes on
the back of the module enclosure.
2.
Place a lock washer and then a washer on the back of each of the four bolts.
3.
Use the socket wrench to lightly tighten all four bolts of the elevation bracket to the unit (do not
over tighten).
4.
Use the torque wrench to evenly tighten down all four bolts and finish the installation of the
elevation bracket to the module (do not over tighten). Follow the Torque setting from Table 7,
“Recommended Torque Values for Elevation Bracket Bolts”.
Figure 11 Attaching Elevation Bracket to Back of Module
6.4.2
Attach Azimuth Bracket
Required parts and tools:
Azimuth bracket and associated hardware from X-1200 Module Installation Kit (See Figure 12,
“Azimuth Bracket and Associated Hardware”)
Socket wrench with 3/8 in. driver head, with long and short ½ in. and 7/16 in. sockets
Torque wrench, 3/8 in. head with range for 4-60Nm or 3-45lbf-ft
Figure 12 Azimuth Bracket and Associated Hardware
6 Mounting Holes
(total)
Use top 4 mounting
holes to attach
elevation bracket
Azimuth Bracket
Bolts and Washers
Orientation
Cut-out (Up)
