BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
19
Issue 01 D1
6.
Use the torque wrench to tighten down all four bolts to finish the installation of the pole/wall
mount bracket to the wall. Base the torque on the third-party hardware bolt specifications and wall
material (do not over tighten).
7.
Install the HM or RBM onto the mounted pole/wall mount bracket. See Chapter 7, “
Installing the Remote Backhaul
” as applicable.
Figure 8 Attaching Assembled Pole/Wall Mount Bracket to Wall
6.4
Assembling the Module Brackets
Assemble the HM or RBM brackets
BEFORE
installing the HM or RBM onto an installed pole/wall mount
bracket. The mounting brackets offer three degrees of adjustment: elevation up-tilt up to 30 degrees,
azimuth up to +/- 25 degrees and theta of up to +/-10%.
6.4.1
Attach Elevation Bracket
Required parts and tools:
Elevation bracket and associated hardware from X-1200 Module Installation Kit (Figure 9,
“Elevation Bracket and Associated Hardware”)
Socket wrench with 3/8 in. driver head, with long and short ½ in. and 7/16 in. sockets
Torque wrench, 3/8 in. head with range for 4-60Nm or 3-45lbf-ft
Clamping brackets are
left in place to prevent
the Pole Mount
bracket from crushing
during bolting.
4X Wall Mounting
Bolts anywhere
within slots
Orientation Cut-out
