Extension brackets can project the
installation brackets up to 2 ½” from the
mounting surface.
Connect the installation brackets with
the machine screw and speed nut
which are included with each extension
bracket. Be sure to use the same hole on
all the extension brackets, so that each
installation bracket projects the same
distance from the mounting surface.
Make sure the tops of the extension brackets are
perfectly horizontal and aligned at the same height and use two
screws to attach to wall. Please refer back to Section D for details.
INSTALLATION
INSTRUCTIONS
Lift&Lock
™
Honeycomb
Shades
www.blindsfirst.com
ships next day, guaranteed
ships next day, guaranteed
%/,1'6),567&20
CUSTOMER SUPPORT: 1-888-553-3811
www.blindsfirst.com
15448
CLEANING AND CARE
In order to keep your window treatments looking new, follow the
recommended methods for care and maintenance. Regular care
will result in better appearance and performance from your window
coverings.
HONEYCOMB: Light Filtering = X / Light Blocking = Z
Dusting Hand-Held
Vacuum
Compressed
Air
Hair Dryer
Spot
Cleaning
Water
Immersion
Ultrasonic
Cleaning
X Z
X Z
X Z
X
Turn
Phillips
Head
Screwdriver
CCW.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
Honeycomb shades
all sizes
INSTALLING EXTENSION BRACKETS (optional)
G
2
.
1
.
INSTALLING YOUR SHADES INTO THE BRACKETS
H
Make sure tab screw is loose, and tab is hanging freely (Fig. 1).
Tilt and slip the inside lip of the headrail over the installation
brackets’ front ledges as shown (Fig. 2).
Raise back of headrail so that it fits completely inside the notches
in the back of brackets (Fig. 3).
To secure headrail to brackets tighten tab screws (Fig. 4).
STANDARD BRACKETS
1
.
2
.
4
.
3
.
To open brackets turn brackets’ arms as shown (Fig. 2).
To secure headrail turn swivel brackets’ arms as shown (Fig. 3).
Slip brackets’ tabs to fit under headrail’s inside lip.
Push arm tight against front of headrail (Fig. 4).
SWIVEL BRACKETS
1
.
2
.
3
.
Press the button on the handle to raise or lower the shade. The shade will
stay in position when the button is released.
OPERATING LIFT&LOCK
™
SHADES
I
If the bottom rail is not level, it can be adjusted by following the
procedure below.
Remove the endcap from the right side of the bottom rail by
pulling the endcap.
Pull out the section labeled TOOL.
Push in on the adjustment screw with the tool, turn clockwise to lower
the right side or counterclockwise to raise the right side.
When the rail is level, replace the tool and the endcap.
LEVELING THE SHADE
J
2
.
1
.
3
.
4
.
5
.
If installing your shade to a door, we recommend installing hold down
brackets to prevent the shade from
swaying when the door is opened
and closed.
With the shade at its full drop, place
the pins on the hold down brackets
into the holes in the bottom rail end
caps and mark where to drill the
mounting holes.
Attach the hold down brackets with one screw through the side hole
or two screws through the end holes. Be sure both bracket pins are
aligned and level.
Hold Down Bracket
Bottom Rail
INSTALLING HOLD DOWN BRACKETS (optional)
K
2
.
1
.
