MODES
Three playback modes can be selected using the mode button on the top right. Pressing the button will cycle through
these modes with the light indicating which one is in use
During audio pass through mode the maximum sample playback is limited to 2. Anything above that will result in
distorted output.
1 - Regular trigger mode.
Warm white light
The device turns on in this default mode.
Audio input is muted
Pressing the buttons will trigger the sample, that is start it and let it play to the end, no matter how long the
button is held down.
2 - Passthrough mode
Purple light
Audio input plays through the output, going through the delay.
Pressing the button on the left mutes the input and triggers any selected sample
3 - Gate mode
Light blue
Holding down the left button allows the input audio to pass through the device
Samples only play back while the button is held down.
In all modes the light will change brightness based on the audio output level.
LOOPING
Each channel can be set to loop the selected samples.
To enable looping for a channel hold its button down and press the mode button. The light will blink white.
Now when you press the button the sample will start playing in a loop. Press it again to stop playback.
Disable loop mode by holding the button down and pressing mode again
CV
CV In
- Frequency modulation
The playback rate of each channel can be modulated using the CV FM inputs
They respond to signals from -5 to 8V
Trig In
Samples will be started when a trigger signal is received on these jacks. In mode 3 the inputs will also act as gates
CV out
- Envelope follower
The output from this jack will follow the output level of the sample played on this channel.
The delay time knob controls the follow rate with a very short release when turned left and a long one on the right.
Sends a signal from 0-9V
