Overview
This product is a professional wire management system that is linked to your
smartphone. The WMS is designed for operating accessories (including lights, horns,
warning beacons, etc.) typically used on work or off-road vehicles (trucks, jeeps,
ATV/UTV, boats, heavy equipment, farm equipment, etc.).
The unit works on 12V DC and provides output to four terminals which are protected
by a 40A fuse.
Please note that before you can operate this system, you need to download and install
BLAZER LINK app for your smartphone.
Installation
1. Please read these instructions carefully before installing this product. It is
recommended to consult a professional installer to prevent damage to vehicle
and/or system.
2. Do not connect to 24V DC or higher voltage system, as this product is designed for
a 12V DC battery system. In case you have a larger than 12V DC system, check
vehicle owner ’s manual to determine if a 12V DC output is available and how to
connect in order to use it safely, otherwise, the product will be damaged.
3. Find a suitable flat surface near the battery, clean the surface free of dirt and oil
and then affix the unit using provided adhesive strips and/or mounting holes.
4. Remove the 40A fuse from the holder and disconnect the vehicle battery.
5. Securely attach the positive (red) cable of the WMS unit to the positive terminal of
the battery (or battery cable) and the negative (black) cable of the WMS to the
negative battery cable or chassis.
6. Attach the auxiliary lights/equipment following correct polarity on the terminals and
not exceeding the maximum amperage of the channels (amperage printed on WMS
and corresponds to amperage printed on the remote control for each terminal).
See FIG 1
7. Reconnect battery cables.
8. Insert the 40A fuse back into its holders and snap the cover closed.
Main Unit
Page 1 of 06
CWL623 OWNER’S MANUAL
BLAZER-INTERNATIONAL.COM
1-800-241-3808
