5
INSTALLATION INSTRUCTIONS
Before Using Your Unit
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the parts per packing list.
•
Before connecting the unit to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
Setting the Temperature Control
•
Your unit has only one control for regulating the temperature in the compartment. The
temperature control is located on the upper right hand side of the compartment.
•
The first time you turn the unit on, set the temperature control to “5”.
•
The range of the temperature control is from position "OFF” to “5”.
“1” is warmer and
“5” is cooler.
After 24 to 48 hours, adjust the temperature control to the setting that best
suits your needs. The setting of “3” should be appropriate for home or office use.
•
To turn the appliance off, turn the temperature control to ”OFF”.
Electrical Connection
•
Turning the temperature control to “OFF” position stops the cooling cycle but does not
shut off the power to the unit.
•
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Installing Your Unit
•
Remove drinks from refrigerator when power is out.
•
Place your unit on a floor that is strong enough to support the unit when it is fully loaded.
To level your unit, adjust the leveling legs at the bottom of the unit.
•
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
•
Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Products service center.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours
before placing drinks in the refrigerator compartment.
Summary of Contents for BLZ-SSRF-40DH
Page 4: ...4 PART LIST ...
Page 8: ...8 Technical Data and Wiring Diagram ...
Page 9: ...9 Packing List ...
