Version 1.0
Blaze Outdoor Products Instructional Book
Page | 22
surfaces, and sharp edges and should make as few bends as possible.
Ensure the gas line connection will be accessible when appliance is installed. A safety shutoff valve is required at
this gas connection point.
If the main burner cotter pins are removed before installing, the main burners must be double checked for
the correct placement in the griddle before operation. When finished ensure that the burners are aligned
with the valve orifice and seated in the bracket slot. This is accomplished by first placing the burner
tube shutter hole securely over the valve orifice and ensuring the male post on the rear of the burner
rests in the corresponding slot in the griddle chassis. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges
will be necessary to allow the griddle to slide flush against the outer front wall to the outdoor kitchen. Due to
differing personal preferences of the size of the notch out, this is recommended to be done at the point of
installation so that the consumer can dictate their preference.
Slide the appliance into the cut out and then attach the gas line.
Be very careful not to kink the gas line when lowering the appliance into the cut out.
Keep your fingers away from where the appliance will be supported on counter. Your fingers could become
trapped and serious injury could occur.
Check to make sure the appliance is level and is supported around the entire outside edge. If the appliance
is not level or is unstable, use non-combustible shims under the outside lip to stabilize it.
Perform the leak test procedure as described earlier in this manual.