4
Introduction
You have just received a Blaze 40 or 60 E (240V/480V or 600V) 40kW or 60kW Electric Construction Heater
manufactured by Campo Equipment Co. Ltd.
Use:
The Blaze 40 or 60 E Electric Construction Heater is designed for temporary heat only. The heater
maybe installed indoors or outdoors and used to bring 100% outdoor air,or heat and re-circulate building air.
The Blaze 40 or 60 E is designed to heat large spaces, buildings and machines without worrying about on
site fuel.
Quality
:The Blaze 40 or 60 E is built with the highest quality of components, giving our
Customers the confidence they deserve in a Ecoblaze product.
Convenience:
The Blaze 40 or 60 E gives our customers the flexibility of a 20kw/40kw or 20kw/40kw/60kw
heat setting respectively.
Colour coded Cam Lock power connections for easy installation. A remote thermostat option is
available.
Safety
NOTE :
Wiring procedures and connections shall be in accordance with the national and local codes having
jurisdiction.
Always verify that you have proper voltage supply.(240V/480V or 600V—
depending on the which version you have purchased) It is important to check the
wiring connections inside the heater before plugging in the Cam Locks.
Use a meter to measure volt supply to each cam lock.
CAUTION:
Work on the internal systems should only be attempted by an authorized service
representative and only when power has been disconnected and cannot be
reconnected to the heater.
Grounding
The heater is supplier with a cam lock system with a grounding connection and is indicated with a "G"
on the cam lock panel. It is very important to double check that all grounding connections are properly
secure.
The appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes with
the
National Electrical Code, ANS/NFPA 70;
or the
Canadian Electrical Code, CSA C22.1