Date Printed: February 15, 2008
15
Version 1.01
GOLD DOOR MAINTENANCE
The gold plating on the door is 24k gold and hence very soft. Do not use any abrasive cleaners on
the gold, just a damp cloth. Use of abrasive cleaners will void the warranty.
CLEANING THE GLASS
While the glass may coat during a low (overnight) burn, adjusting the thermostat to the warmest
setting after reloading each morning will usually allow the glass to clean.
Heavier deposits may
require hand cleaning. Manual glass cleaning should be done when the stove and glass are cold.
DO NOT CLEAN THE GLASS WHILE IT IS HOT
. Use a soft cloth and wood stove glass cleaner,
available from most Blaze King dealers. Other NONABRASIVE household cleaners may also work.
After using any cleaner, thoroughly rinse the glass with water to remove any deposits left by the
cleaner. Failure to remove all traces of glass cleaner will result in the glass cleaner residue baking
on. This residue will be very difficult to remove.
LOADING DOOR GLASS REPLACEMENT
Your BLAZE KING is equipped with a door which uses a strong, heat resistant ceramic glass
intended to withstand extremely high temperatures and tested for continuous use above 1200
degrees Fahrenheit. However, this glass can be broken through improper use. If glass replacement
becomes necessary, use only BLAZE KING replacements. DO NOT SUBSTITUTE ANY OTHER
MATERIAL FOR THIS PURPOSE.
WARNING
BROKEN DOOR GLASS IS SHARP. ALWAYS WEAR EYE PROTECTION AND PROTECTIVE
GLOVES WHEN HANDLING GLASS. DISCARD THE GLASS IN A CLOSED CONTAINER
INACCESSIBLE TO CHILDREN.
l) Allow the fire to completely burn out and the stove to cool down.
2) Retain all parts for re-installation.
3) Open the door and remove the twelve (12) # 10 x 3/8" screws holding the six retainers to the
inside of the door.
4) Remove the damaged glass and the old glass gasket.
5) Install the replacement glass gasket around the outer perimeter. Place the glass in the door
frame. Be sure the words "Blaze King" etched in the glass reads correctly when the door is closed.
6) Install the retainers with the 10 x 3/8" screws. A drop of penetrating oil on each screw will facilitate
easy installation.
