OM-SC30.1 E V1.01
January 20, 2015
Page 19
SC30
.1
INSTALLATION INSTRUCTIONS cont.
TOOLS NEEDED FOR INSTALLATION:
5/32” allen key and a square (Robertson #2)
screwdriver.
INSTALLATION
1. Lean stove backwards to gain access to
stove bottom.
2. Remove “ASH CHANNEL SEAL” by
unscrewing the four #10 screws. Remove
the 1/4” nut and bottom plate
Fig. A
.
3. Th
read all four 1/4”-20 button head cap
screws into the stove base until halfway
(included w/ pedestal kit).
4. Remove the ash drawer from the
assembled pedestal. (Can also remove
pedestal back panel if needed)
5. Utilizing the key holes on the top of the
pedestal body, slide the pedestal into place
by pushing it against the bottom of the
stove and then pushing it towards the back
of the stove (use the half turned in screws
as guide pins)
Fig. B
.
6. Once the pedestal is in position, fi nish
tightening the four screws into the stove
bottom and lift stove into its upright
position.
7. Insert the ash drawer into the pedestal
front. (Reattach pedestal back panel if
removed during install)
8. Insert ash plug from pedestal kit into stove
fi rebox.
PEDESTAL (Z3903BK)
NOTE: EITHER PEDESTAL OR LEG KIT(see next page) MUST BE INSTALLED BEFORE STOVE
CAN BE DUCTED AND READY FOR USE.
