DATE PRINTED: 2/8/05 Revision Date: 04/15/04
OM-2205 Page 23
MAINTENANCE
♦
GOLD PLATING:
1. Gold plating requires little maintenance and need only to be
cleaned with a soft damp cloth.
Do not use any abrasive
cleaning materials.
2. Avoid fingerprints on gold. Wipe off fingerprints before
firing.
♦
DOOR :
1. Check the gasket to see that it is still forming a seal.
replace gasket if there is any sign of wear.
2. Check the door catches.
♦
GLASS PANEL REPLACEMENT:
This appliance is supplied with high temperature 5mm
Ceramic glass that will easily withstand the heat your unit was
designed to produce. In the event the glass breaks, have a
qualified service technician replace the complete door assembly
using manufactures original parts.
Wear durable work gloves to handle broken glass or
removal of loose glass for disposal and safe handling prior
to shipping or delivery of door / glazing frame to a qualified
service center for repair.
♦
REMOVING THE BLOWER:
1. Turn the gas off to the unit.
2. Turn off/unplug the electric supply.
3. Remove the door of the unit.
4. Remove the log set and brick panels.
5. Remove the burner.
6. Remove the burner tray (4 screws).
7. Remove the blower access panel in the back of the firebox.
8. Pull the fan unit out far enough so you can disconnect the
terminals.
9. Pull the blower assembly through the firebox through the
door. Be careful you do not snag and damage the electrical
connections.
10. Replacing the assembly is the reverse of the above
Instructions
♦
GAS VALVE REPLACEMENT:
1. Disconnect electricity to the appliance.
2. Shut off the gas to the appliance and disconnect the gas
line to the appliance.
3. If the appliance has a remote switch or thermostat,
disconnect the wires at the front of the valve.
4. Remove the logs.
5. Remove the burner.
6. Disconnect valve wiring.
7. Undo the four screws holding the valve plate to the firebox
side.
8. Gently rotate the valve to gain access to the pilot tube nut
and burner supply tube nut.
9. Carefully undo the pilot and burner supply tubes and
remove the valve.
10. Replacing the assembly is the reverse of the above
instructions.
♦
REMOVING THE BURNER ORIFICE
1. Use a wrench to loosen and remove the orifice.
2. Change the orifice.
DO NOT OPERATE APPLIANCE WITH THE GLASS DOOR REMOVED, OPEN, CRACKED, OR
BROKEN. REPLACEMENT OF GLASS SHOULD BE DONE BY A LICENSED OR QUALIFIED
SERVICE PERSON AS AUTHORIZED BY BLAZE KING. DO NOT ATTEMPT TO REMOVE
DOOR OR REPLACE GLASS
•
USE ONLY THE GLASS DOOR CERTIFIED WITH THIS APPLIANCE
•
Maintenance should be performed by a Qualified Service Technician.
•
Do not use substitute materials.
•
Do not abuse the glass door, such as striking it or slamming it shut.
•
Do not use abrasive cleaners to clean the glass.
•
DO NOT CLEAN GLASS WHILE DOOR IS HOT!!