Remote Control
Disclaimer
•
•
Recycling and Disposal
Do not dispose of your old unit in the
household trash!
Use the return and collection systems
available to dispose of the old device.
This manual may be updated from time to time without
any notice.
In no event shall Blaupunkt be liable for any direct,
indirect, punitive, incidental, special consequential
damages, to property or life, improper storage,
whatsoever arising out of or connected with the use
or misuse of our products.
USA & CANADA : Product not intended for sale in
the United States and Canada. If purchased in the
U.S. or Canada, this product is purchased as-is. No
warranty, express or implied is provided in the U.S.
and Canada.
Proper system planning is vital in order to maximize the
device’s performance and road safety. Plan your instal-
lation carefully to avoid compromising performance re-
liability of the system. Consult an authorized Blaupunkt
dealer for installation or reparation. Read the manual
carefully before operating the device for the first time.
Safety Notes
Ensure to follow below safety notes during installation
and wiring connection : -
•
•
•
•
Installation and Connection Instructions
•
•
•
Intergrated Fuse
•
Switching On/Off
•
Voltage Supply
•
•
•
•
1
2
INTRODUCTION
Disconnect the negative terminal of the battery.
Refer to the safety notes of vehicle manufacturer.
Ensure positions of the holes are nowhere near the
vehicle component to avoid any damage during
drilling.
Ensure cross section of the cable is no less than
2.5mm2 if the positive and negative cables are too
long.
Incorrect installation may result in malfunction of
the device or the car sound system.
Select a dry and well-ventilated location to install
the device.
The device must not be installed on the rear shelf,
rear seats or exposed locations.
The installation location must be suitable for
screw holes and have stable ground support.
The integrated fuse in the device protects the
output voltage and the entire electrical system in
case of malfunction. Do not replace damaged fuse
with higher current.
This device will automatically turn on if audio sig-
nal is detected. The device will also automatically
turn off if audio signal is received.
Use the supplied power extension cable to connect
to the positive battery terminal.
Firmly and carefully connect the ground lead to a
bare metal point on the vehicle chassis.
The control of the device should be a two-channel
control, either via the preamplifier output of the
car sound system.
A control solely via the right or left channel is also
possible since the low-frequency portion of the
music is generally identical on both channels.
1. Power Indicator
2. Gain Adjustment
Turn the gain knob to adjust
the volume to the desired
level.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
POWER LIGHT
PROTECTION LED LIGHT
PHASE (00~ 1800)
LOW PASS (50Hz~ 150Hz)
BASS BOOST (0 ~ +12dB)
INPUT GAIN
REMOTE CONTROL INPUT
HIGH INPUT
FUSE
GND
REMOTE
BATT
FUNCTIONS CONTROLLING DIAGRAM
(H
z)
(dB)
1 2 3 4
5
6
7
8
9
10 11 12
(Hz)
(dB)
