Blaupunkt WKSK 757101, Manual

Page: 15 / 20

Assembly Instructions
Carefully unpack the angle grinder. Ensure you have all the components listed in the table.
KEY DESCRIPTION QTY
A Angle grinder 1
B Auxiliary handle 1
C Grinding disc 1
D Flange wrench 1
E Disc guard 1
Installing The Auxiliary Handle (Fig. 1)
The auxiliary handle must always be used to prevent loss of control and possible injury.
• Install the auxiliary handle (1) by turning the screw (2) clockwise into the gear housing (3)
• The handle can be installed in three different positions; left side, right side or in the middle of the tool (Fig. 6, 7 & 8).
• Tighten the auxiliary handle securely.
Fig. 1 Fig. 2 Fig. 3
Installing The Guard (Fig. 2 & 3)
The guard must be installed before installing a grinding disc or using the angle grinder. Failure to do so could result in serious
personal injury. The guard must be positioned correctly to protect the operator. Guard placement depends upon which side of the
tool the auxiliary handle is used, it should be positioned to give the greatest protection for the user.
• Depress the spindle lock button (1) and rotate the clamp nut (2) until the spindle locks.
• Turn the clamp nut anticlockwise and remove it from the spindle.
• Remove the disc flange (4). It will simply pull off the spindle (5).
• Pull the guard clamp lever (6) outward to allow the guard clamp to expand for installation.
• Slide the guard clamp (7) over the spindle housing (8) until the blade guard locating indents (9) fit into the groove (10) in the
spindle housing
• Rotate the guard so it is positioned correctly depending upon the location of the side handle in Fig. 4, 5 & 6.
• Close the guard clamp lever (6) fully so that the guard firmly locks into position.