Blaupunkt RX+ 12, Instruction Manual

Page: 40 / 43

RX+ 12
FM OPERATION
1. In DAB band, if you want to listen FM radio, please press
Band
to switch
to FM band.
2. In FM mode, press
Scan
button to auto tune station. Short press the
Scan
button and the unit will search for radio frequency automatically.
When it finds a station with strong signal, the unit will stop searching and
will play this station. Short press the
Scan
button for high frequency auto
tuning, long press the
Scan
button for lower frequency auto tuning.
3. If you want to manual tune the frequency, press or button to adjust
it. The frequency will up or down 0.05MHz each.
4. In FM mode, when the station includes RDS message the unit can
synchronize this information. At this point press the
Info
button to view
the signal strength and radio stations RDS content.
5. In FM mode, press the
Enter
button to switch the audio stereo and mono
output (stereo only can be listen by using headphones, because the
speaker is mono output).
6. The station preset operation is the same as in DAB mode.
7. Auto tune sensitivity settings: long press the
Enter
key to enter setup
interface, it will show sensitivity scale, press or button to adjust the
FM auto tune sensitivity, turn to left side will auto tune strong signal
station only; and turn to right side will auto tune include weak signal
station as well. After adjustment, please press the
Enter
button to confirm.
The radio will resume to previous station and play.
8. When playing the radio, you can press
VOL-
(volume down) or
VOL+
(volume up) button to adjust a suitable volume.
SYSTEM OPERATION
1. In
POWER ON
mode, you can view the software version by long press .
2. System reset operation, in power on mode, long press the key, there
will show the contents of the software version; short press the
key again,
the display will show “
System reset
” , short press the
Enter
key, the display
will show “
Press Enter Key to Reset
”. Press the
Enter
button again to start
the system reset operation. The display will show “
ok
” once the system
reset is completed. The device will enter in the DAB band radio scan
directly.
3. Earphone output: plug in the stereo 3.5mm earphone connector into
the earphone jack in the bottom left corner of rear panel, meanwhile, the
speaker will stop to play music, and you can listen the music via earphone.
40