2
Safety information
–
Faulty installation or servicing of this
equipment may result in malfunc-
tions in the vehicle’s electronic sys-
tems.
–
To prevent damage to your TravelPi-
lot, be sure to use the correct adapt-
er cable to connect the vehicle 8-pin
+/- ISO plug.
Observe the following safety information
while installing and connecting the
system:
–
Disconnect the negative terminal of
the battery.
–
In doing so, observe the safety infor-
mation provided by the vehicle man-
ufacturer.
–
Make sure not to damage any vehi-
cle parts when you drill holes.
–
The cross-section of the positive and
negative wiring must not be less than
18GA.
–
Use wire bushings for sharp-edged
holes.
–
The TravelPilot can be used in vehi-
cles with:
• 12 V battery power
• Negative pole on the chassis
Information on proper
installation
To ensure that the TravelPilot functions
properly, it is essential that the system
be calibrated after it has been complete-
ly installed (see Operating instructions
/ Contents / Calibration).
The system determines the distance trav-
elled via its connection to the vehicle speed-
ometer signal. If there is no speedometer
signal, it will be necessary to have a wheel
sensor mounted by an authorized custom-
er service center.
In this case you will have to order a sen-
sor kit (wheel sensor, magnet strip,
bracket and plug) from your dealer.
Order-No.: 7 607 611 093
Installation instructions
