Blaupunkt LS 275e, Instruction Manual

Page: 44 / 61

LS 275e
The only means of completely disconnecting the product from the power supply is
by removing the power cord from the wall outlet or the product. The wall outlet or
the power cord entry to the product must remain freely accessible at all times while
the product is in use.
Try to install the product near a wall socket or extension cord and shall be easily
accessible.
The highest environmental temperature suitable for this product is 35°C.
ESD hints - If the product maybe reset or not reset to operation of control due to
electrostatic discharge, just switch off and reconnect again, or move the product to
another location.
Battery
24.
25.
26.
27.
28.
The batteries must not be exposed to excessive heat such as sunshine, fire or
the like.
The batteries should be drawn to the environmental aspects of battery
disposal.
Battery usage CAUTION-to prevent battery leakage which may result in body
injuries, property damage, or damage to the apparatus:
Install all batteries correctly, + and – as marked on the apparatus.
Do not mix batteries (old and new or carbon and alkaline, etc.)
Remove batteries when the unit is not used for a long time. 1).
2).
3).
ERP 2- (Energy Related Products Directive) note:
This product with ecodesign complies with the stage 2 requirements of Commission
Regulation (EC) NO. 1275/2008 implementing Directive 2009/125/EC regarding to
standby and off mode electric power consumption of electronic household and office
equipment. After 15 minutes without any audio input, the system will automatically
switch into standby mode. Follow up the instruction manual to resume the operation.
Important note:
This device is equipped with an energy saving mode: if no signal is given during 15
minutes the device will switch automatically into standby mode in order to save energy
(
ERP 2 standard). Please note that low volume setting in the audio source may be
recognized as “no audio signal” : this will affect the capability of signal detection from the
device and can also originate an automatic switch into standby mode. If this happens
please reactivate the audio signal transmission or increase the volume setting on the
audio source player (DVD player, TV, etc.), in order to resume playback. Please contact the
local service center if the problem remains.
44