DANSK
9
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
SPECIFICATIONS
be connected to the positive terminal at
a distance of max. 30 cm from the vehi-
cle battery (if necessary, drill a hole in
the bulkhead and use the appropriate
cable grommets).
Switching positive
Connect the switching positive cable (2)
(see Fig. 1) to the switching positive
output (ignition
) of the main de-
vice (e.g. car radio or navigation device).
If connecting to terminal 15 of the vehi-
cle, protect the switching positive cable
(2) by installing a fuse holder (1A fuse)
at a maximum distance of 20 cm from
the point of connection.
Negative (ground) connection
Attach the negative cable (1) (earth/
GND, (3), see Fig. 1) directly to the ve-
hicle body using a screw. Scratch the
surface down to the bare metal at the
point at which the earth contact is made
and apply graphite grease (important for
a good earth connection).
• If the installation requires holes to be
drilled or any other changes to be
made to the vehicle, please contact
a specialist workshop in your area.
Note:
You cannot display PAL video on the
wide vision TV monitor using the RGB
input.
In this case, the PAL video signal must
be connected directly to the AV input of
the wide vision TV monitor.
Specifications
Video input:
Composite Video, 1.0 Vpp, 75 Ohm
RGB output (video signal, internal
resistance 75 ohm):
Typical 0.7 Vpp
RGB output (composite sync, inter-
nal resistance 75 ohm):
Typical 1.0 Vpp
Power supply:
DC12V, +/- 10%, max. 1A
Features
1 Video input:
Cinch jack
1 RGB output:
15-pin Sub-D plug-type connector
Conversion:
CCVS (NTSC/PAL) in RGB 50/60 Hz
Power input:
4-pin plug-type connector
Metal housing
INSTALLATION
