Blaupunkt HOR301, Owner'S Manual

Page: 9 / 92

7
B - Handle
D - Power-switch knob
A - Radiator fins
C - Thermostat knob
2. Set the switch from the “0” position to “ ” (minimum heating power), “ ” (medium heating
power), or “ ” (maximum heating power).
3. Turn the thermostat knob clockwise to the maximum position. When the room temperature rises to a
comfortable level, slowly rotate the thermostat counter-clockwise until the status lamp goes out. Turn
the thermostat knob clockwise to increase the required temperature. In order to decrease the
temperature, turn the knob counter-clockwise. The radiator will try to maintain the set room
temperature by switching on and off.
4. To switch off the radiator, set the power switch to the “0” position and the thermostat knob to the
minimum position. Disconnect the product from the mains.
1. Make sure that the appliance's power switch is set to the “0” position, and the thermostat is set to the
minimum value. Connect the plug to the power source.
3. Put the “U”-shaped metal part through the radiator and insert its ends into the flat component.
Screw down with the wing nuts.
USING THE APPLIANCE
Overturning protection
BEFORE THE FIRST USE
During use, clean the appliance regularly according to the following instructions.
1. Disconnect the appliance from the power source, and let it cool down before cleaning.
2. Gently clean the appliance's external surface and control panel with a damp and lint-free cloth.
The radiator is protected with overheating protection which automatically switches off the appliance
if it intensely overheats. In that event, disconnect the appliance from the mains, wait approx. 30
minutes for the radiator to cool down, and rectify any possible cause of the overheating, e.g.,
something covering the radiator. Check the appliance, cable, and plug for damage. If no damage is
observed, reconnect the appliance and switch it on, according to the manual. If the radiator does not
switch on, contact the customer service for assistance.
1. Turn the radiator upside down.
2. Fit the flat components holding the castors
The radiator is protected by a safety switch, which automatically switches off the appliance if the
heater overturns, or is at too acute an angle to the horizontal. This helps prevent accidents, and the
radiator will resume its operation when it is put back on.
OVERHEATING PROTECTION
Fix the castors to the bottom part of the radiator according to the diagram in the Figure. Figure 5
applies to model HOR301 only.
4. Place the radiator on a level, stable, and heat-resistant surface.
CLEANING AND MAINTENANCE
HOR301 / HOR401 / HOR501
TECHNICAL DATA
E - Cable reel
F - Flat castor-fixing components
G - Castors
Model/Parameter
Power supply
Power
HOR301
220-240V~50Hz
1500W
HOR401
2000W
HOR501
2500W