Setting the Timer
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined
up with the arrow pointer, i.e. if the time the timer is being set is 8 p.m., rotate the outer
ring until the number 20 is in line with the arrow pointer.
Set the time the heater is required to run by pulling the segments around the outer
ring forward appropriate to the running period(s) required.
When set, the heater will operate each day during the times programmed. Note, the
heater must always be plugged into a power socket, the element switches must be in
the on position and the thermostat must be suitably set to ensure the heater will come
on. If the heater is required to run continuously the slide switch on the timer should be
set to the “I” position. If it is subsequently required to revert back to timer operation,
the slide switch on the timer should be set to the central (clock) position.
Note: When using in timer mode, due consideration should be given to the fact that
the heater may come on whilst unattended.
Always ensure the heater is placed correctly according to the warnings.
4
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow it to cool down before cleaning
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust
and stored in a clean dry place.
