9
9
Attaching the stand
ATTACHING THE STAND
3 x ST (3.7x18)
5 x M(4x10)
1
1/2
1
2
3
8)
Screws that are included.
3 x
ST (3.7x18)
5 x
M (4x10)
Used for attaching the stand neck
to the TV (fi g.1)
Used for attaching the stand base
to the stand neck (fi g.3)
(fi g.1) Attach the stand neck to the rear of the TV set
using the 5 x M(4x10) screws provided.
(fi g.2) Peel off the protective plastic cover then attach
the stand base to the stand neck.
(fi g.3) Secure the base to the neck by using the
3 x ST (3.7x18) screws provided.
When securing the self-tapping screws into the base of the stand (on fi rst
installation) the screws will be naturally tight as they are creating a thread
in the plastic of the stand neck in order to support a TV of this size.
a)
Ensure the cross head screw driver tip fi ts correctly into the head of the
screw and that it is not too big or small.
b)
Screw in all screws individually and partially before tightening all of the
screws individually and partially until they are fully inserted.
c)
If they become very tight try loosening them slightly and then re-
tightening them once again as this will continue the process of creating the
thread for the screws.
Attaching the stand
To complete the stand installation you will require a cross head screw driver
User Guide - 32-148I-GB-5B2-HKUP-UK - BLA-MAN-0233.indd Sec1:9
User Guide - 32-148I-GB-5B2-HKUP-UK - BLA-MAN-0233.indd Sec1:9
10/15/2014 4:21:15 PM
10/15/2014 4:21:15 PM
