9
Note… Do not move
or don the limb while
reset is processing
otherwise this will
prolong the reset
time.
Battery
Charger
LED
Battery
Charger
6
Battery Charging
(continued)
Battery Charger LED
Charging State
Yellow
Standby
Green > fast flashing
Fast charging
Green > slow flashing
Close to full charge
Green
Maintain (trickle charge)
Yellow > fast flashing
Error (Ensure Battery Switch is
ON
[
I
])
Device
LED
*You can enable or disable the
audible reset confirmation by
pressing and holding the [+]
and [-] buttons simultaneously
for 2 seconds. The change
will be confirmed by 2 short
beeps.
Note… If the charger LED is yellow and the Limb is
making a clicking noise check that the Battery switch is in
the
ON
[
I
]
position.
Fully charge the battery before first use.
We recommend that the device should be fully charged
every night. It should take 8 hours to charge fully (from fully
discharged). We also recommend battery charging whenever
convenient.
Step-by-Step Guide:
1. Lay the limb on a flat surface.
2. Ensure the mating surfaces of the magnetic charging
connector and terminal are clean (see Section 4).
3. Magnetically join the charging connector to the charging
terminal at the posterior of the knee and check alignment is
correct (see Section 6.1).
4. Switch the Battery On/Off switch to
ON
[
I
].
5. Check the Battery Charger LED is flashing green to confirm
the battery is charging.
6. Refer to table below to ensure Limb is charging.
7. Disconnect from the charger when charged sufficiently and
refit terminal cover.
8. Wait for 30 seconds while observing the device LED
changing color as indicated:
Device
LED
Red
Blue
Red
Green
Off
9. After a successful reset sequence, 2 short beeps will be
heard (if this alert is not disabled; see* below).
10. If reset sequence is unsuccessful or the LED remains Red,
switch the battery
OFF
[
O
] then
ON
[
I
] and repeat from
step 8.
Magnetic
Connector
Device
938354V2APK1/1-0321
