12
4.6
Connecting the drive motor to the traction wheel
4.7
Driving with connected drive motor
Set the driving speed at the desired speed using the speed control
knob(3). Place 1 hand on the handle grip and squeeze the switch
lever (10), this will move the machine forwards, this is the normal
working direction for blasting. Release the switch lever to stop. The
driving speed can be adjusted while driving by turning the speed
control knob (3).
The OVERDRIVE-button (5) makes it possible to drive at maximum
speed without having to adjust the speed control knob. To do so,
press and hold the OVERDRIVE-button (5) while driving.
WARNING!
Mind your surroundings at maximum speed!
The BACKWARD-button (4) is used to drive backward, press and hold
the button to do so.
WARNING!
Do not drive backward while
blasting! This function is only used for maneuvering without blasting.
Make sure the dust hose and electrical cable are out of the way when
driving backward.
Set the drive speed
knob (3) to the lowest
possible setting,
approximately 0,5.
Open the wheel guard.
Insert the quick release
pin inside the hole.
!WARNING!
Use
only 1 finger
to
press the button of the
quick release pin, and
keep applying
pressure.
Make sure the magnetic
valve is CLOSED.
Make sure the Blast
motor is OFF.
Danger of crushing!
Use common sense, do
not get distracted
during the activities.
Use your other hand to
operate the drive-
motor handle (10).
1
2
3
5
6
7
When the drive-motor
and wheel are aligned,
the quick release pin
will lock into place.
Close wheel guard.
4
8
