BRB-1600 Machine Manual
© 2011 Blastpro Manufacturing Inc.
®
7
8. Move control levers forward to start removal. It is recommended to make a single
pass in one direction to expose an edge of the material to be removed. Subsequent
passes should be made perpendicular to the initial pass. See figure 3.1.1.
1
2
3
4
5
6
7
8
9
Figure 3.1.1
3.2: Shut Down
At end of shift or workday:
1. Move machine to level ground for storage.
2. Use the rocker switch in the left control lever to lower the cylinders until the front
caster lifts off of the ground.
3. Rotate motor switch to “OFF” position.
4. Depress E-stop.
For long term storage:
1. Move machine to level ground in a secure location for storage.
2. Lift blade to upper-most position.
3. Rotate motor switch to “OFF” position.
4. Depress E-stop.
5. Remove the blade and/or the blade holder from the front of the machine.
6. Operator should be firmly seated in operator’s seat.
7. Pull E-stop out.
8. Rotate motor switch to “ON” position.
9. Use the rocker switch in the right control lever to lower the cylinders until the front
caster lifts off of the ground.
10. Rotate motor switch to “OFF” position.
11. Depress E-stop.
12. Cover the machine to protect it from dust and moisture.
