2
MANUAL CONTENTS
1. Use protective equipment: Abrasive-resistant clothing, safety shoes, leather gloves, ear protection,
CE-approved air-fed helmet. Air for helmet must be supplied by a breathing air compressor or through
a helmet air filter.
2. Check for possible silicosis hazards. Avoid dust.
3. Do not blast with damaged or worn equipment.
4. Point nozzle only at area being cleaned.
5.
Use only proper dry and well-screened abrasives specifically intended for blasting.
6. Keep unprotected workers out of the blast area.
7. Before blasting:
•
Check fittings and hose for wear.
• Safety-wire couplings together.
•
Check helmet filters and air supply.
• Check pop-up valve for alignment.
• Test remote controls.
• Make sure blast machine is adequately grounded.
8. Do not weld on blast machine, this voids approval.
9.
Do not substitute Krimetal parts or modified equipment in any way.
WARNING
INTRODUCTION
3 Description
3
Set-Up and Operation
MAINTENANCE
5
Leather Dust Seal (Pos.10)
5
Tungsten Carbide Washer (Pos.12)
5
Nozzles (Pos.29-33)
5
Nozzle Head (Pos.1) and Plug (Pos.2)
5
Brake Lining (Pos.5)
5
Lockring / Bearing Seal (Pos.7 & Pos.9)
TROUBLESHOOTING
6 Troubleshooting
