User Manual professional h.264 & MPEG2 encoder MPE-4000
MPE-4000-MPEG-encoder-manual-RR-03-2018.docx
Page 11 / 44
HD Encoder:
to indicate the device name.
XX.XX/XX.XX Mbps:
to indicate the current encoding Bit Rate and total Output Bit Rate
FMT:
to indicate source signal resolution format
VP/AP:
to indicate the Video and Audio Signal source port.
VEN-FMT:
to indicate the video encode format.
ACH-CMT:
to indicate the audio Capture Mode.
AEN-1 to AEN-4:
to indicate the 4 channel audio encode format.
General Settings for the Main Menu
Press “
LOCK
” key on the front panel to enable the main menu. The LCD will show the following
pages where you can configure the parameters for the device:
You can press UP/DOWN/LEFT/RIGHT buttons to specify menu item, and then press ENTER to
enter the submenus as below:
ALARM STATUS
The alarm indicator will turn on if signal source loses or encoding errors occur. You can then
enter this menu to check the error type.
SYSTEM SETTING
1 Alarm Status 2 System Setting
3 Audio Setting 4 Video Setting
5 Save Config 6 Load Config
7 Language 8 Versions
