10
EMA x08/407
Part N
o
: 917x.xx
ENCODER/ MULTIPLEXER
SDI/ A/V
→
ASI(TS) & IP(TS)
HDMI
→
ASI(TS) & IP(TS)
A
LINE
3.3.2 Configuration menu (HTML page)
The configuration menu will appear on successful log-in. It is divided into the two following sections:
1. Status information and help functions
Change Passwort, Help, Factory setting, Set Date & Time and Status xxx (if enabled)
2. Configuration
Ethernet Interface, General Selection
Please note:
If any changes made to the configuration in the section “General Selection“, these changes are to be saved in the device to
unlock the corresponding configuration options. To do this, the button “Save to Device“ is to be pressed.
3.3.2.1 Status information/ help functions
Fig. 5: Web interface, status information/ help functions
Status :
Technical informations und status indication for service und remote maintenance, e.g. 190: bit rate overview, 192: service
tables.
Change Password:
The password for the configuration access is a maximum of eight characters; allowed characters: Letters in uppercase and
lowercase letters and numbers (no special characters, no umlauts).
Factory setting:
All parameters are set to the values of the factory default. The process takes about 10 seconds. During this time no transport
stream signal is available. In this function, the set IP address is
not
reset to factory default.
Please note:
“Factory setting“
by pressing on the button of the rear side of the device resets the IP address to 192.168.2.86 and the password to “neu“.
Set Date & Time:
Transfer of the PC‘s settings date and time on the device.
Download MIB:
All parameters of the device can be alternatively set via the “Simple Network Management Protocol“
.
The required structure
file “ME.mib“ (Management Information Base) for the management software is available for download here.
Note:
The MIB is in accordance with the currently adjusted device configuration dynamically created and deployed on the
device. That means, if in “General Selection“ configuration changes must be made and stored, the new MIB has to be loaded
for further SNMP configuration.
Table Extention:
Calling a script command (expert mode) for programming of special configurations. The activation of the function is carried
out under the “Channel MUX“.
3.3.2.2 Settable parameters
(Anything pre-set under “Factory Setting” will be underlined in the display.)
3.3.2.2.1 Ethernet interface (control port)
Fig. 6: Settings for the Ethernet network interface
