6
TECHNICAL INFORMATION FOR
INSTALLATION PERSONNEL
This appliance shall be installed only by authorised
persons and in accordance with the manufacturer's
installation instructions, local gas fitting regulations,
municipal building codes, electrical wiring
regulations, AS 5601/AG 601 - Gas Installations and
any other statutory regulations.
The wall and bench surfaces must be capable of
sustaining temperatures of 75 degrees Celsius.
All laminates, fixing adhesive and surfacing materials
should be certified suitable for this temperature.
Any adjoining wall surface situated within 200mm from the
edge of any hob burner must be a suitable non-
combustible material for a height of 150mm for the entire
length of the hob. Any combustible construction above the
hotplate must be at least 650mm above the top of the
burner and no construction shall be within 450mm above
the top of the burner. A minimum depth of 60mm from the
top of the worktop surface must be provided for the
appliance.
3) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In case of
doubt, do not use the appliance and contact qualified
personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within children’s
reach since they could become potential sources of
danger.
The measurements of the opening made in the top of the
modular cabinet and into which the hot plate will be installed are
indicated in fig. 7.
Always comply with the measurements given for the hole into
wich the appliance will be recessed (see fig. 7 and 8).
The appliance belongs to class 3 and is therefore subject
to all the provisions established by the provisions
governing such appliances.
INSTALLATION
FIG. 7
FIG. 8
COMPLY WITH THE DIMENSIONS
A
B
C
D
E
4F (860)
833
475
62.5
62.5 73.5 min.
