USE AND MAINTENANCE
• It is recommended to operate the appliance prior to cooking.
It is recommended to leave the appliance in operation for 15 minutes after cooking is terminated in order to
help eliminate cooking vapors and odors.
The proper function of the rangehood is conditioned by the regularity of the maintenance operations, in par-
ticular, the active carbon filter.
• The anti-grease filters capture the grease particles suspended in the air, and are therefore subject to clogging
according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2 months by carrying
out the following instructions:
- Remove the filters from the rangehood and wash them in a solution of water and neutral liquid detergent,
leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminum panels may alter in colour after several washes. This is not cause for customer complaint nor
replacement of panels.
• The active carbon filters help to purify the air that is replaced in the environment. The filters are not washable
nor reusable and must be replaced at maximum every four months. The saturation of the active carbon filter
depends on the frequency of use of the appliance, by the type of cooking and the regularity of cleaning the
anti-grease filters.
• Clean the fan and other surfaces of the rangehood regularly using a cloth moistened with denatured alcohol
or non abrasive liquid detergent.
• The light function is designed for use during cooking and not for prolonged general illumination of the envi
-
ronment. Prolonged use will notably reduce the duration of the bulb.
Light replacement - incandescent
.
• Remove the aluminium filters from the range hood.
• Un-screw the globe.
• Replace the globe.
• Re-install the aluminium filters.
Globe: Tubular E14 40Watts 240volts
• Light replacement - halogeN
12 volt 20 W Halogen.
Remove the glass retaining ring and glass.
Replace the globe with another of the same type.
Replace the glass and retaining ring.
• Controls (fig.8)
Symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
G = MOTOR WORKING INDICATOR
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING
THE ABOVE WARNINGS.