GENERAL
Carefully read the following important information regarding installation safety and maintenance.
Keep this information booklet accessible for further consultations. The appliance has been designed
for use in the ducting version (air exhaust to the outside), filtering version (air circulation on the
inside) or with external motor.
SAFETY PRECAUTION
1. Take care when the rangehood is operating simultaneously with an open fireplace or burner that
depend on the air in the environment and are supplied by other than electrical energy, as the
rangehood removes the air from the environment which a burner or fireplace need for combustion.
The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Provide adequate
ventilation in the environment for a safe operation of the rangehood. Follow the local laws applicable
for external air evacuation.
Before connecting the model to the electricity network:
Inspect the data plate (positioned inside the appliance) to ascertain that the voltage and power
correspond to the network and the socket is suitable. If in doubt ask a qualified electrician.
General Warnings.
similarly qualified person in order to avoid a hazard.
appliances burning gas or other fuels.
Warnings for Installation:
appliances burning gas or other fuels.
lowest part of the rangehood must be at least 65 cm.
INSTALLATION INSTRUCTIONS
• Electric Connection
The appliance has been manufactured as a class II, therefore no earth cable is necessary. The
connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided,
connect a plug for the electrical load indicated on the description label. Where a plug is provided, the
rangehood must be installed in order that the plug is easily accessible. An omnipolar switch with a
minimum opening of 3mm between contacts, in line with the electrical load and local standards, must
be placed between the appliance and the network in the case of direct connection to the electrical
network.
• The minimum distance between the support surfaces of the cooking pots on the cooker top and the
lowest part of the rangehood must be at least 65 cm. If a connection tube composed of two parts is
used, the upper part must be placed outside the lower part. Do not connect the rangehood exhaust
to the same conductor used to circulate hot air or for evacuating fumes from other appliances
generated by other than an electrical source. In the case of assembly of the appliance in the
exhausting version prepare the hole for evacuation of the air.
INSTALLATION
The following instruction should be followed to carry out the correct installation of the rangehood .
1) Mounting of the rangehood on the lower side of the cupboard.
2) Selection of the version (extraction or filtration)
Mounting the rangehood on the lower side of the cupboard. This appliance must be fitted to a
cupboard or other suitable support. For fixing use 4 screws suitable for the cupboard, using the hole
NOTE: Any electrical work MUST be completed by an authorised person.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for their safety. Children should be supervised to insure that they do not play with the appliance.
Caution: Accessible parts may become hot when used with a cooking appliance.
Warning: Failure to install the screws or fixing devices in accordance with the instructions may result
in an electrical hazard.
