SAFETY INSTRUCTIONS
1. Operate only in a well-vented area.
2. Do not shake cans that leak or are deformed. Periodically
check for leakage during mix cycle.
3. Do not operate machine if electrical cords are cracked or
frayed.
4. Disconnect from power source when working on
machine.
5. Shaker must be placed on solid, level surface well clear
of any obstructions.
6. Never leave any operating machine unattended.
NEW MACHINE SETUP
1. Remove Shaker and parts from package. Place Shaker
on a rigid, level surface, away from any edge, and well clear
of obstructions.
2. Install bracket assembly to platform with side hole to the
right.
3. Route power cord so that it will not be damaged and plug
into grounded receptacle.
4. READ OPERATION INSTRUCTIONS and post it in a
conspicuous place.
MAINTENANCE
NOTICE: FAILURE TO FOLLOW MAINTENANCE PROCE-
DURES VOIDS WARRANTY.
1. Wipe paint spills immediately. Accumulations of paint may
detract from your Shaker’s performance and
reliability.
2. Check and tighten all fasteners periodically.
3. Periodically examine cords and wiring for damage.
Damaged cords must be immediately replaced.
GENERAL OPERATING INSTRUCTIONS
1. Thread the clamping screw (P/N 51069) with the lock nut
attached through the bar as shown. Install this into the hold-
down bar by inserting it through the hole while simultane-
ously pushing in the locking pin.
2. Insert the can as shown, then turn the clamping screw
until the hold-down bar securely clamps the can, making
sure the nut remains free on the screw.
3. After the can is clamped, then turn the lock nut down the
screw until it tightens against the bar.
HINT: To make sure that the nut is tight, simultaneously give
both the nut and the screw an extra 1/4 turn.
4. The motor is started by rotating the timer switch. Turn
past the desired time by 2 minutes, then set timer. Due to the
varying states of unmixed paint, it is impossible to give specific
mixing times for your paint, however, a little experience will
soon show how quickly your particular paint can be mixed.
SPECIAL INSTRUCTIONS
FOR RECTANGULAR GALLONS
1. Remove the hold-down bar and clamping screw and set
them aside.
2. Loosen both knobs (P/N 51032) and slide the right side of
top bar toward the front of the machine (right end of the
top bar is slotted).
3. Slide the can onto the platform with the top bar between
the handle and the spout.
4. Center the can on the platform* and secure the cap by
tightening both knobs evenly and firmly until the can is
clamped securely.
*NOTE: FULL RECTANGULAR GALLONS OF PRIMER
SHOULD NOT BE CENTERED, BUT PLACED TO THE LEFT
SIDE OF THE PLATFORM.
INSTALLATION OF SPRINGS
TOOLS REQUIRED: Channel-Lock pliers, 3/16" hex key and
5/32" hex key.
Round
Gallon
Aerosol
Nozzle
Rectangle
Gallon
Quart
Bottom of
Pint