BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
18
SECTION 5
PREVENTIVE MAINTENANCE
The running belt can shift to one side or simply
‘skid over’ when running. To center the belt using
the 6mm Allen wrench, run the machine at 3mph
for a few minutes to determine which side the belt
is drifting towards; left or right.
If the belt is drifting left
i) Turn the treadmill off and unplug from the
machine.
ii) Tighten the left bolt a ¼ turn (clockwise).
iii) Loosen the right bolt a ¼ turn
(counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt continues to drift to the left, repeat
steps.
If the belt is drifting right
i) Turn the treadmill off and unplug from the
machine.
ii) Tighten the right bolt a ¼ turn (clockwise).
iii) Loosen the left bolt a ¼ turn
(counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt continues to drift to the right, repeat
steps.
Once the running belt has been adjusted closer
to the center, the treadmill can be powered on
again.
It is recommended that the deck be lubricated
every 6~12 months according to the frequency of
usage.
Use 6mm Allen wrench to loosen the bolts in the
end caps. Remove excessive accumulations of dust,
dirt, and other substances from running deck. Use a
clean soft cloth.
Warning!
Do not use cleaner under the running
belt.
Pull up running belt, dispense lubricant on
deck, and spread evenly.
After lubricating deck, center the belt, and tighten
the end caps. Check belt condition and adjust if
necessary referring to the steps above.
Rear Roller Bolt
6 mm wrench
0.5~4.0 Mile lubricate every 1 year
4.0~7.0 Mile lubricate every 6 months
7.0~10.0 Mile lubricate every 3 months
