8
9
13. Mount the LED lights into the body.
A flashing red LED is mounted at
the top of the body behind the
main shaft and a 6-inch extension
is plugged into it. A solid clear LED
is mounted in the lower nose of the
body. The other red solid LED will
be mounted later in the manual.
These can be glued in with contact
cement or silicone. Tape the wires
to the side of the body so they will
not interfere with the mechanics of
the heli.
14. Thread the wire tail skid into the
tail rotor mount. Thread it in until
all of the threads are completely in
the housing.
15. Use a 1.5mm hex driver to start the
2mm (0.07-inch) setscrew into the
bottom screw boss on the tail rotor
mount. Do not thread this all the way
in yet.
16. Mount the tail motor to the tail rotor
mount using the 1mm x 3mm (0.03
x 0.1-inch) machine screws, washers
and a #0 Phillips screwdriver.
Note that this motor is wired with
reversed polarity due to the tail
motor being on the opposite side of
a conventional CP series helicopter.
This motor must be used for the tail
rotor to spin in the correct direction.
17. Run the tail motor leads through
the mount as shown. Also mount
and run the rear RED solid LED.
You will need a 6-inch and a 12-inch
extension plugged
together for the rear LED to reach
the front of the body. Plug these
in now also. Tape the motor leads
and the LED leads together to aid in
routing them through the tail section.
18. Slide the tail motor leads and light
wires, if used, through the opening in
the rear tail section of the fuselage.
Route them through the fuselage into
the front section.
19. Slide the tail motor mount assembly
into the tail section of the fuselage
through the opening.
