8
EN
Routing the Wiring
There are two leads included with the CGO2 GB
gimbal:
• 3-wire signal lead with a servo style connector
and a 3-pin JST connector.
• 2-wire power lead with a 4-pin balance connector
and a 2-pin JST connector.
Route the leads as follows:
1. Plug the servo connector of the signal lead into the
rearmost pins on the fl ight control board as shown
at right, with the brown wire toward the outside.
2. Route the JST connector through the hole in the
landing gear mount on the bottom of the 350 QX.
3. Route the JST connector of the power lead down
through the hole in the opposite gear mount on
the bottom of the 350 QX, leaving the balance
connector loose inside the battery compartment.
1
2
3
2
3
