14
EN
Installation
1. Install the included hook and loop tape on the bottom of
the camera, as shown.
2. Install the camera on the model using the included hook
and loop strap.
3. Connect the servo lead from the main board to the
camera servo lead port. If the camera does not function
through the transmitter after connection, disconnect the
lead, rotate the connector and reconnect it so the lead is
in the reverse orientation.
4. Press the camera power button. The blue and red LEDs
will blink back and forth once, then the blue LED will
glow solid.
Changing Modes
The camera comes from the factory in still mode. Each
time you power ON the camera, it will default to still mode.
To change between video and still mode, press and hold
the trigger for 3 seconds. When changing to video mode,
the blue LED will blink twice. When changing back to still
mode, the blue LED will blink once.
Operation
Press the camera power button. To use the camera, press
and release the trigger on the back of the RTF transmitter.
This will take a picture or start recording video. Press the
trigger again to stop recording video depending on the
mode the camera is currently in. When taking a picture, the
blue LED will turn off, then return to solid. When recording
video, the blue LED will blink slowly and return to solid
when fi nished recording.
BNF Transmitters
To use the camera function with other transmitters, assign
channel 6 to a momentary switch/button on your transmit-
ter. The switch/button will function the same as the RTF
trigger.
The camera also functions manually through the buttons.
Data Retrieval
Data from the camera can be retrieved through the micro
USB port or the removable 2GB TF micro SD card.
To retrieve data through the micro USB port, connect the
included USB cable to the camera and your computer. The
red and blue LEDs will blink rapidly when transferring data.
When data transfer is complete, the red and blue LEDs will
blink slowly, indicating charging.
Powering OFF the Camera
Press and hold the power button for 2 seconds to power
OFF the camera. The red and blue LEDs will blink rapidly
for 2 seconds, then camera will power OFF.