4: Maintenance
The spot welding machine shall avoid bumping and damp as far as possible, and the welding
machine shall be shut down during storage. After optimization, the power consumption of the
shutdown gear is very small, which can stand by for more than one year. The power consumption
of gear 1-5 is large. Although there is a low power shutdown function, it is still necessary
to avoid it!!
For normal use, it needs to be fully charged. The type-C charge is not divided into positive
and negative to ensure that 5V > 500mA. During charging, the indicator light turns red and
full green. At this time, it can be welded. Please pay attention to the shell temperature when
it is used for a long time. When the temperature is higher than 60 ℃, protect the power off.
In order to prolong the life of the energy storage battery as much as possible, it is not
necessary to charge the battery too full. It is enough to charge for 2-3 hours. (long term
storage)
5: Simple troubleshooting
After reading the advanced skills in Section 3, it is necessary to understand and practice
the principle of electric welding.
<Jump back to the power off gear>. It may be out of power. Charge. If the buzzer is silent
at this time, it can also be charged,
< cant charge > check whether the USB charging port is damaged and the wiring is burned.
When pulling and inserting, it should be straight and straight, and can not be pulled back
and forth.
Check whether the battery is dead, open the two welding pens, and measure the voltage with
a multimeter as the battery voltage..
The above faults may be encountered by novice players and can be easily checked. I collected
them for the reference of fans.
The welding machine has been improved for many times, the hardware and software are very
mature, normal use will not be damaged, default users read this manual. The point is to use
it as an important tool for you, not to tinker with it. If it is damaged by misoperation,
please contact me to solve the problem. If the battery and circuit board are seriously damaged,
you should pay the maintenance cost according to the situation.
