11
10
3. Footswitch
A 2-way footswitch can be connected here. The footswitch will enable the selection
of the Clean and Overdrive channels, and the two voices on each Channel.
NOTE:
using a footswitch will disable the front panel channel and voice switches.
Therefore, full control via the footswitch is granted irrespective of how the amplifier
is set.
EXTERNAL SWITCHING:
This can also be used by people who wish to control
the main features of the amp using an external switching device that connects via
the TRS connection of the socket.
The following external conditions will switch the channels and voices as follows:
TIP
RING
CHANNEL
VOICE
Closed
Closed
Clean
Voice 1
Closed
Open
Clean
Voice 2
Open
Closed
Overdrive
Voice 1
Open
Open
Overdrive
Voice 2
4. Emulated Output USB Socket
This B-type USB socket is for connection to a computer via a suitable lead (not
supplied). The output will be a stereo, fully processed guitar signal complete with
speaker cabinet emulation and stereo reverb.
Standard audio drivers are used to connect the amplifier to a PC, Mac or other
applicable recording device. No specific drivers are required.
For a guide on low latency USB recording visit:
www.blackstaramps.com/usbrecording
NOTE:
Always connect the amplifier via a main USB port, often found on the rear
of the computer.
The amplifier will appear as an audio capture device within recording software.
English
English
Technical Specification
HT-1R MkII
Power (RMS):
1 Watt
Valves:
1 x ECC82, 1 x ECC83
Weight (kg)
: 5.6
Dimensions (mm):
311 x 306 x 178
Footswitch:
FS-16 (not included)
Speaker:
Custom Designed 8"
HT-1RH MkII
Power (RMS):
1 Watt
Valves:
1 x ECC82, 1 x ECC83
Weight (kg)
: 3.7
Dimensions (mm):
273 x 187 x 174
Footswitch:
FS-16 (not included)
