11
10
your amplifier will ‘scan’ for previously paired devices within range and attempt to
reconnect, starting with the device that was most recently connected. You will hear
an audible tone from the amplifier to indicate that a device has been successfully
reconnected.
If you have previously paired any Bluetooth Devices to your FLY 3 Bluetooth amplifier
it will power on in Scanning Mode. If your Bluetooth device is within range and has
Bluetooth connectivity switched on, your amplifier will automatically reconnect to
your device, allowing you to start streaming your music straight away.
Pressing the Bluetooth switch from Scanning Mode will set your amplifier to
Discoverable Mode in order to begin pairing a new device.
At any time, you may disconnect your Bluetooth device from your amplifier by either
pressing and holding the Bluetooth switch on the amplifier front panel for 3 seconds
or switching off the Bluetooth functionality of your device. You will hear an audible
tone from the amplifier to indicate that a device has been disconnected.
13. Bluetooth LED
The Bluetooth LED indicates which mode the Bluetooth is in (Discoverable/
Scanning). When the Bluetooth LED is unlit the Bluetooth connectivity is not active.
Rear Panel
1. DC Input (PSU-1)
Connect external Power supply here
ONLY USE A BLACKSTAR APPROVED POWER SUPPLY (PSU-1)
6.5V 1.5A min.
2. Battery Compartment
Insert batteries here for portable use. We recommend using
rechargeable (NiMH) or Alkaline batteries in your FLY 3 to
get the most out of using it on the go.
6 x AA batteries (rechargeable).
3. Extension Cabinet (FLY103)
Connect your FLY 3 to a FLY 103
using the FLY 103’s built-in cable to
create a 6W stereo set-up.
(Extension cabinet sold separately)
English
