Blackrock Microsystems CerePlex Exilis, Instructions For Use Manual

Page: 8 / 20

Revision 2.00 / LB-0889
– CerePlex Exilis: Instructions for Use
© 2019 Blackrock Microsystems, LLC
8
performance. Data from the amplifier is encoded and transmitted to the receiving
antennas by an on-board radio and antenna. The battery and power-on indicator
LEDs, as well as the impedance mode switch and micro USB port are shown in
Figure 1 .
CerePlex Exilis On/Off Switching
Power to the CerePlex Exilis headstage is provided by a rechargeable lithium-ion
battery housed within the headstage. A magnetic reed switch is used to power
cycle the device. To turn the power on or off, swipe the magnetic wand provided
with the system across the area shown in
Figure 2 .
CerePlex Exilis Battery and Charging
When the battery is low, the battery status LED will turn RED for about 5 minutes
before it is completely turned off. The battery can be recharged by connecting the
CerePlex Exilis headstage to the wireless receiver using the included 5-wire
micro-USB cable. The battery status LED will turn YELLOW while the headstage
is actively charging and will turn GREEN when charging is complete (
Figure 3 ).
Use caution when removing the micro-USB cable as excessive force or twisting
can damage the connector on the headstage.
Figure 2 – Power cycling the Exilis.
Figure 3 – Battery status indicators.